![]() ![]() Establish 2 DI points (Btn_Start, Btn_Stop) and 1 DO point (MotorCtrl) in the controller label. Fill in strictly according to this parameterĦ.This step sequence is also very important, RPI recommends to fill in 50msħ. Please refer to the red box mark in the figure below for detailed settings. The sequence of this step is very important. Select the corresponding I/OModule and click Create.ĥ. In the IO configuration, right-click on the rack and select New Module.Ĥ. Choose 30 for version, 1756-A7 for rack, or others, choose 2 for Slot, click Finish.ģ. Open the Studio 5000 programming software, select the Controller you want to simulate, fill in the Name, and click Next.Ģ. Create a simulated IO module in slot 3, the method is the same as above.ġ. Select CPU 0, other options are defaulted, and click Enter.ħ. Select 30 for Version, and other options are defaulted. Select the Controller you want to simulate, select 2 in Slot, and click OK.Ĥ. In slot 2, right-click and select Ctreate.ģ. ![]() Its function is to connect the computer to the emulator with RS LINX, To simulate a physical PLC.Ģ. ![]() Open Emulate v30 simulation software, the default interface is as shown in the figure below, slot 0 is RS LINX, slot 1 is computer, these two slots are occupied by default and cannot be deleted. ![]() For example, if you have installed Emulate v30, you don’t need to install a lower version of the simulation software, you can simulate the Studio 5000 v20 to v30 program.ġ. The version number of Emulate simulation software is backward compatible, including previous version numbers. What is the PLC programming software version, the simulation software needs to use the corresponding version, for example: Use Studio 5000 v30 to program, Emulate simulation software must use the v30 version Ģ. Now let’s take a look at how to use this simulation software.ġ. The simulation software Studio 5000 Logix Emulate for AB PLC has a simple interface and powerful functions. In the process of learning AB PLC programming, if there is no AB PLC around and you want to verify the program logic, then simulation software is a good choice. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |